Apexis Products And Technology Forum
Would you like to react to this message? Create an account in a few clicks or log in to continue.

Apexis Products And Technology Forum

In order to let everybody know apexis products and services, and help everybody in the use of apexis network camera products issues.
 
HomeSearchRegisterLog in

 

 How to flash a BMW DME or EGS with WinKFP

Go down 
AuthorMessage
obd2tool



Posts : 74
Join date : 2012-04-28

How to flash a BMW DME or EGS with WinKFP Empty
PostSubject: How to flash a BMW DME or EGS with WinKFP   How to flash a BMW DME or EGS with WinKFP I_icon_minitimeThu Sep 16, 2021 6:50 pm

Here is the guide to set up and flash a DME or EGS. Look at the steps starting at “Open up WinKFP” below.

– Install BMW Standard Tools 2.12 (EDIBAS, INPA, WinKFP, NCS Expert) and ensure they work with your car.
– WinKFP 5.1.6 (no earlier version than this)
– INPA 5 or higher
– Get the daten files (download, extract from Progman or Ista/p).
– E39 daten files: rapidshare.com E39_V41_Daten_Files.rar
– E46 daten files: rapidshare.com E46_V41_Daten_Files.rar
– See these instructions for extracting the daten files from Ista/p.

– Have jumper cables to another car battery supplying a minimum of 10A power.
– Connect the K-line cable to OBD port on car and USB port on computer.
– Turn the ignition key to position 2.
– Open up WinKFP.
– Select Configuration
– Uncheck Fast baudrate.
– To not increment the flash update counter, uncheck all UIF checkboxes.
– Click OK, cancel all the prompts about creating the new config files, click Ok to save to INI file.
– Select F1 Comfort Mode.
– Select F3 Update ZUSB.
– Select the ECU to update (ex: GD20, GD8604, MDS43, MDS451, etc.).
– Select F4 Enter VIN and paste in the full VIN for the car.
– Select F8 Done.
– Select F3 Prog. ZB-Update to detect current version and latest available update version.
– Click OK to begin flashing.
– It takes 43 minutes for MS45.1, 20 minutes for MS43, 7 minutes for GD20, 12 minutes for GD8604).
– After the confirmation message of flash update complete, close WinKFP.
– Wait one minute.
– Turn off the ignition key.
– Wait one minute.
– Turn on the ignition key to position 2.
– Clear adaptations using either BMW Diagnostic Software INPA or PA Soft 1.4:
– Start INPA, select DME, Errors, Adaptations.
– Start PA Soft 1.4, select Units, select DME/DDE, select called “DME-EWS Adaptations”.
– Clear any error codes in both DME and EGS. Turn off key for one minute. Try again. Do this until all are cleared.
loading..

http://obd2trade.com/2021/06/28/how-to-flash-a-bmw-dme-or-egs-with-winkfp/
Back to top Go down
 
How to flash a BMW DME or EGS with WinKFP
Back to top 
Page 1 of 1

Permissions in this forum:You cannot reply to topics in this forum
Apexis Products And Technology Forum :: Forum :: Apexis IP Camera-
Jump to: